LOCO COOKERS 2023070128 Manual Del Propietário página 5

• Introduction of water or ice from any source
into the oil/grease may cause overflow and
sever burns from hot oil and water splatter.
When cooking with oil/grease, all food products
MUST be completely THAWED and towel
DRIED before being immersed in the cooking
disc.
• Avoid bumping of or impact with the appliance
to prevent spillage or splashing of hot cooking
liquid.
• Never drop food or accessories into hot
cooking liquid. Lower food and accessories
slowly into the cooking liquid in order to
prevent splashing or overflow. When removing
food from the appliance, care shall be taken to
avoid burns from hot cooking liquids.
• The pressure regulator and hose assembly
supplied with the appliance must be used.
Replacement pressure regulators and hose
assemblies shall be those specified by the
appliance manufacturer. Replace only with
regulator Model No. KR-126B+GDH1 or 101E
Series.
• Hot cooking liquids can remain dangerously
hot long after cooking. Never handle the
cooking appliance until the cooking liquid has
cooled to less than 115ºF (46ºC).
• The minimum outside operating temperature
of this appliance is 32ºF (0ºC). Never use this
appliance when temperature is below this
minimum.
• Use caution when in close proximity to
appliance. Falling or tripping near the gas
appliance may result in the splashing or
igniting of hot cooking liquids and potentially
cause personal injury or property damage.
• Keep the cooking area adjacent to the
appliance clear of debris and free of anything
flammable or combustible.
• Never attempt to attach this appliance to the
self-contained LP gas system of a camper,
trailer or motor home.
• Check burner/venturi tubes for insects and
insect nests and clean if necessary. A clogged
tube can lead to a fire beneath the appliance.
lococookers.com
WARNINGS
• Non-rechargeable batteries are not to be
recharged. Batteries are to be inserted with the
correct polarity. Exhausted batteries are to be
removed from the product. DO NOT DISPOSE
OF BATTERIES IN A FIRE. BATTERIES MAY
EXPLODE OR LEAK.
• The manufacturer has properly located the
burner with respect to the orifice to allow
the appliance to burn sufficiently. Please do
not attempt to adjust the burner. It is preset
to the factory specifications.
• The burner should be removed and
cleaned occasionally. When the burner
is reassembled, align the threads of the
regulator hose to the center line of the
burner and wrench-tighten. Doing this is
critical for maximum performance and
efficiency.
Burner
Regulator Hose
4