Publicidad
Idiomas disponibles
Idiomas disponibles
routing to subgroups 3 and 4, panning hard left will route the signal to group output 3 only, and panning hard right will
route to group output 4 only.
14. ON/OFF Switch
Turn this switch on to send the signal to the buses. The switch lights orange when on.
15. Clip LED
The clip-led lights up when the input signal is driven too high. If this happens, back off the Trim control and, if
necessary
16. Solo Switch
The solo switch is used to route the channel signal to the solo bus (Solo In Place) or to the PFL bus (Pre Fader Listen).
This enables you to listen to a channel signal without affecting the main output signal. The signal you hear is taken
either before the pan control (PFL, mono) or after the pan and channel fader.
17. SUB Switch 1-2
The SUB switch routes the signal to the corresponding subgroups.
18. SUB Switch 3-4
The SUB switch routes the signal to the
corresponding subgroups.
19. Main Switch
This switch aligns the main.
20. Channel Fader
Adjusts the level if the channel signal. Use these
faders to adjust the balance between the various
channels.
21. BT-Function
Contact mobile phone or tablet.
Connecting: Press the "contact switch" for two
seconds, then the signal LED light up, use your
mobile phone
or tablet and choose "PD Power Dynamics" BT-
connection.
22. A. Effector Level Light
Show the effect level stronger.
B. Effector Display
Show the kind of effector
C. Mp3 Play Window
Show the MP3 time, song name and other play
instruction.
23. FX Control
The aux send jacks carries the master aux mix (from
the channel FX controls).You can connect this to an
external effects device to process the FX bus. The
processed signal can then be brought from the effects
device back into the Stereo Aux return jacks.
24. Program Dial
You can select the effect preset by turning the
program control. The display flashes with the number
of the current preset. To recall the selected preset,
press on the button; the flashing stops. You can also
recall the selected preset with the foot switch.
25. Aux Control
With this fader you can control the Aux output jack.
26. 9-Band Stereo Graphic Equalizer
The graphic stereo equalizer allows you to tailor the
sound to the room acoustics.
27. Headphone/Room Level
Use this control to adjust the output level of
headphone.
28. Aux return Stereo
Adjusts the level at which the signal received at the
return jacks (L and R), is sent to the stereo L/R bus.
29. CD/PC Control
Adjusts the level of the signal sent from de CD IN
jacks. Computer USB audio input & sound control.
30. MP3 Switch same as No. 14.
31. FX Switch same as No. 14.
32. Same as No. 15,16,17,18,19
33. FX Send Fader
Control effect input signal level & Send FX Jack input.
34. MP3 Fader
Control effect input signal level.
35. Computer USB Contacted Jack
Used USB cable line to contact with computer & mixer. Mixer could be play the computer audio and computer could be
recording the mixer output audio.
5
Publicidad
