Ryobi P2808 Manual Del Operador página 12

WARNING:
If this product is used for herbicide/insecticide applica-
tions do not re-purpose it for use with disinfectants.
Obtain a second nozzle set and tool for dedicated use
with disinfectants only. Tools used for used for herbicide/
insecticide applications are regulated under EPA Federal
Insecticide, Fungicide, and Rodenticide Act regulations
and are considered contaminated.
FILLING THE TANK
See Figures 4 - 5.
WARNING:
Before filling the tank, always remove the battery pack.
Wipe up any spills before inserting the battery pack. Fol-
lowing this rule will reduce the risk of electric shock and
corrosive liquids entering the battery pack, which can
cause battery pack failure including short circuit resulting
in smoke, fire, and/or serious personal injury.
WARNING:
Always follow the chemical manufacturer's instructions
printed on their product labeling, SDS sheet and/or EPA
Master Label for use, cleaning, and storage. Clean thor-
oughly after each use, following the instructions in the
Maintenance section of this manual. Chemicals should
be stored out of the reach of children. Failure to do so
may result in serious personal injury.
WARNING:
Improper mixing, combining or application of spray prod-
ucts or solutions can result in SEVERE INJURY or DEATH.
Follow all CDC and EPA guidelines. Follow the chemical
manufacturers instructions printed on their product label-
ing, SDS sheet and/or EPA Master Label.
WARNING:
Do not allow conductive or corrosive fluids to get inside
the battery pack. If conductive or corrosive fluids are
spilled on the battery, refer to the instructions in your
battery operators manual.
OPERATION
NOTICE:
Disconnect tank and fill away from sprayer. Clean the
exterior of the tank and clean up any spillage before
reconnecting tank.
When adding spray solutions, you may add water and the
desired chemical solution directly into the tank, or use a
solution that has been premixed in a separate container,
then poured into the sprayer, using a funnel if needed. For
either method, remember:
 Liquids used must be as thin as water. Thicker liquids will
not spray properly.
 Do not overfill the tank.
NOTE: If using a measuring container or funnel to fill the
tank, be sure to thoroughly clean and rinse these items after
use. If premixing the spraying solution, rinse the container
used for mixing.
To fill:
 Move the sprayer away from the tank when filling.
 Turn off the electrostatic function and remove the battery
from the unit.
 Unscrew the cap and remove it from the tank.
 Fill the tank with the desired liquid, up to 3 gal..
NOTE: To ensure proper operation of the sprayer, DO
NOT fill past the max fill line.
 Screw the cap back onto the tank, making sure it is
tightened securely.
NOTE: Wipe the outside of the tank with a dry cloth and
clean up any spills before connecting the tank.
 Reinstall the battery pack.
NOTICE:
It is important to thoroughly clean the unit after each use.
Allowing liquid to remain in an idle tool for an extended
period may cause its moving pieces and connectors to
seize up.
INSTALLING/REMOVING BATTERY PACK
See Figure 6.
Always remove battery pack from your tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
To install:
 Align the grooves on the battery pack with the raised ribs
in the battery port and place the battery pack in the tool.
8 — English
WARNING: