Publicidad
Idiomas disponibles
Idiomas disponibles
AFTER USE
•
Before you put down the tool, switch off the motor and ensure that all moving parts have come to
a complete standstill.
•
After switching off the tool, never stop the rotation of the accessory by a lateral force applied
against it.
DESCRIPTION
A Speed regulator
B Locking knob on/off switch
C On/Off switch
D Polishing disk
PREPARATION
•
Mount the handle in upright position onto the machine and tighten it with supplied inner hex
screws and the 6 mm hex spanner (G).
•
Position the supplied spanner onto the hexagon of the drive shaft.
•
Turn the outer thread of the polishing disc into the inner thread of the drive shaft and hand tighten
it by holding the spanner and turning the polishing disc in a clockwise direction.
USE
•
Mounting of accessories
o disconnect the plug
o simply press sponge pad (E) onto hook & loop polishing disk (D)
o for removing accessories handle vice-versa
•
Before using the tool
o ensure that accessory is correctly mounted and firmly tightened
o check if accessory runs freely by turning it by hand
o test-run tool for at least 30 seconds at highest no-load speed in a safe position
o stop immediately in case of considerable vibration or other defects and check tool to
determine the cause
•
On/Off
o switch on/off the tool by pulling/releasing trigger (C).
•
Switch locking for continuous use
o pull trigger (C)
o press knob (B) with your thumb
o unlock the switch by pulling again trigger (C) and then releasing it
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
E Sponge pad
F Ventilation slots
G Hex spanner 6 mm
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
