Sauder Cannery Bridge Serie Manual Del Usuario página 21

Step 17
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten a DOOR (G) to the LEFT END (B) as shown in
å
the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
Fasten a PULL (53K) to the DOOR (G). Use two BLACK
å
1-1/8" MACHINE SCREWS (21S).
Peel a FELT DISC from the FELT DISC CARD (1M) and
å
stick it on the DOOR where it comes in contact with
the UPRIGHT (C).
Repeat this step for the other DOOR (G).
å
See the next step for DOOR adjustments.
å
1M
www.sauder.com/services
G
53K
21S
BLACK 1-1/8" MACHINE SCREW
(4 used in this step)
419151
Hinge
B
C
Stop
Mounting
screw
Page 21