Ruby TIBER 100 Manual De Instrucciones página 42

OPERATING INSTRUCTIONS
Note:
• Ensure the supply power is in correspondence with the value on the nameplate.
• Ensure the water tank is correctly fi tted before the dehumidifi er can be switched on.
• If the dehumidifi er is turned off and then turned back on again immediately, it will take approximately
3 minutes to reach full power (compressor back to work).
• If the dehumidifi er switched off by a power cut, it will automatically switch back on once the power
is restored.
• The dehumidifi er works best at normal ambient temperature falls to below 15ºC .
Switching On/Off The Unit
Connect the mains lead to socket.
Press Power button once to turn on the unit. By default, it runs on Manual Dehumidifying Mode.
Press Power button once again to turn off the unit.
Humidity Setting Control
Press Manual button once to enter Manual Dehumidifying Mode or to select desired level of humidity
from CO-30%-35%-40%-45%-50%-55%-60%-65%-70%-75%-80%-CO.
Note: If ambient humidity lower than 30%, display shows LO.
If ambient humidity higher than 90%, display shows HI.
42