LYTEQUEST WASH7 Manual Del Usuario página 7

NOTE:
1. The machine has a function that automatically recognizes the DMX or SLAVE signal.
2. When a parameter is changed and the "ENTER" button is pressed, the new value is saved after
"... ..." is displayed on the digital display.
Setting Up
Unplug the power cord before replacing a fuse and always replace it with the same type of fuse.
Power supply: Before plugging in your unit, make sure the voltage source in your area matches the
voltage required for your unit. The light is available in a 110V to 220V version. Since line voltage can
vary from location to location, you should be sure your unit voltage matches the wall outlet voltage
before attempting to operate your unit.
Replacing Fuses
With a flathead screwdriver, pry the fuse out of its socket.
Remove the damaged fuse from its holder and replace it with a fuse of the same type. Insert the fuse
holder in its place and reconnect it.
Linkage Attachment
You will need a serial data link to display light from one or more fixtures using a DMX-512 controller or
run synchronized to two or more fixtures set to master/slave operation. The combined number of
channels required by all fixtures on a serial data link determines the number of fixtures the data link can
support. Maximum recommended distance of the serial data link: 500 meters (1640 feet).
Maximum recommended number of fixtures on a serial data link: 32 fixtures
Master/Slave :
1. Connect the 3-pin (male) connector of the DMX cable to the 3-pin (female) connector of the first
fixture.
2. Connect the end of the cable from the first fixture that has a 3-pin (female) connector to the input
connector of the next fixture that has a 3-pin (male) connector. Then proceed to connect the output
shown above to the input of the next fixture, etc.
12
MENU :
To select menu or exit
UP : Increase (next) setting
DOWN : Decrease (previous) setting
ENTER : Confirm or enter sub-menu
Orientation:
This unit can be moved to any position as long as there is enough room for ventilation
Access the control panel functions using the four panel buttons located directly below the display.
Control Panel Navigation:
Access the control panel functions using the four panel buttons located directly below the display.
Menu Map:
Six distinct operating modes, many with sub-modes, are supported by the unit. To select, use the
"MODE / ESC" button to access the menu.
The "UP" and "DOWN" buttons confirm any selection. After a few seconds, the LED display will turn
over during operation until another button is pressed on the built-in program mode.
User Settings :
Setting the maximum pan angles
To select, use the "MODE / ESC" button and choose "PA18", "PA36" or "PA54". The UP and DOWN
buttons coincide between all available PAN angles.
Press the ENTER button to confirm your selection.
To select, use the "MODE / ESC" button and choose "t.9", "t.18" "UP" and "DOWN" cycle between all
available tilt angles.
Press the "ENTER" button to confirm the chosen selection
Reverse or Normal Pan
To select, use the "MODE / ESC" button and choose "Pan" (normal) or "Pan" (reverse).
The UP and DOWN buttons cycle between the two settings. Press the "ENTER" button to confirm the
confirm the chosen selection
Reverse or Normal Tilt Setting
To select, use the MODE / ESC button and choose t. L (normal) or rt. l (reverse). The UP and DOWN
buttons coincide between the two settings. Press the ENTER button to confirm the confirm the chosen
selection
13