Publicidad
Idiomas disponibles
Idiomas disponibles
Siphon Feed
TO USE
1.
Mix material according the
manufacturer's instructions. Mixture
should be smooth and easily pourable.
Lumps or foreign particles should be
removed by straining through a
suitable paint filter.
NOTE: When applying heavy bodied paints,
the Air Cap (included, part number
D26452) is recommended.
NOTE: If not using the siphon feed setting,
see "Internal Pressure Feed" or "Remote
Pressure Feed" paragraphs.
2.
Fill the material cup (e) 3/4 full.
3.
Attach material cup (e) to the gun
securely.
4.
Attach air supply line to 1/4 NPT air
inlet (c).
5.
Adjust spray pattern.
a.
The position of the air cap horns (g) will
determine the spray pattern. Loosen air
cap (h) and rotate horns to achieve
desired pattern. Tighten air cap.
6.
Turn fluid control knob (b) clockwise until it
stops, do not force. This will shut off the fluid flow. NOTE: The fluid or
density of "fan spray" is controlled by fluid control knob (b).
7.
Adjust air pressure to 50 psi at air compressor.
8.
Turn air valve control knob (a)
counterclockwise until first thread is flush with
gun body. NOTE: Air flow is controlled by air
valve control knob (a).
knob out until the first thread is past the gun
body. They are under pressure when the gun
is triggered and could leave the gun with
force.
NOTE: Care should be exercised when handling spray gun to avoid damage to
the orifice of the air cap and tip of fluid nozzle. Damage to these parts results in
irregular spray patterns.
9.
Depress spray gun trigger (d) and gradually turn the fluid control knob (b)
counterclockwise until desired fluid flow is reached. Trigger gun quickly, one
second on-off to test pattern.
injury.
NOTE: If gun sprays too fast, decrease the air and fluid pressure. If too slow,
increase the pressure. Turn fluid control knob (b) counterclockwise to increase,
or clockwise to decrease, the fluid flow. Turn air valve control knob (a) counter-
clockwise to increase, or clockwise to decrease, the air flow.
NOTE: When using the internal mix air cap, begin with the same air and fluid
pressure.
DO NOT exceed 60 psi.
DO NOT turn air valve
control knob or fluid control
NEVER point spray gun at self or any other person. Ac-
cidental discharge of material may result in serious
5- ENG
g
h
f
Horizontal position
Vertical position
first thread flush
a
b
c
d
e
a
b
D28262
Publicidad
