Publicidad
Idiomas disponibles
Idiomas disponibles
Before starting an installation variant, the assembly bracket (b)
must be set to its basic position. To do this, turn the lower safety
screw on the mounting bracket (b) counterclockwise so that the
bracket opens. Do not turn the screw completely, but only until
the bracket loosens and it fits into the grooves on the back of
the housing.
Remove the transport protection between the dowl bar and the
housing.
MOUNTING ON THE WALL
ATTENTION! Make sure that you have a load-bearing surface
1.
For mounting on a solid stone/concrete wall, please use the plastic dowels
(i). Determine the dimensions and height of the projection screen surface
to determine the position of the mounting brackets (b). Draw a horizontal
line (spirit level) to bring both mounting brackets to the same height. Use
the mounting brackets as a guide and mark the holes on the wall with a
pencil. Then drill holes according to the markings with a drill and insert
the dowels into the holes (the dowels must be seated tightly in the holes).
Fasten the mounting brackets to theto the wall with the screws (c).
2.
Now lift the screen housing with two people and carefully insert it into
the mounting brackets. Make sure that the housing profiles engage in the
hooks of the mounting brackets. Now let the case go slowly downwards
and do not let go until the housing is actually held by the bracket (in both
hook lugs).
1. Hold the housing in
front of the bracket
and push it from below
so that the upper edge
goes against the top of
the bracket.
2. Push the housing
towards the wall until
it is noticeably on the
hooks.
3.
As
soon
as
housing is securely on
the bracket, turn the
lower
safety
clockwise
to
ten the bracket. This
closes the bracket and
the housing is moved a
little upwards.
the
screw
tigh-
5
Publicidad
