Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP
• The Honeywell Ceramic Tower Heater requires no assembly. Simply unpack heater and save all packaging materials for off-
season storage.
• Place the heater on a firm, level, open surface free from obstructions and at least 3 feet (0.9m) away from any wall or
combustible material.
• DO NOT use on an unstable surface such as bedding or deep carpeting.
• BE SURE THE HEATER IS NOT IN A POSITION WHERE IT MAY BE TRIPPED OVER BY CHILDREN OR PETS.
MOVING THE HEATER
• This heater is equipped with a Cool Touch handle for your convenience.
• Turn off the heater.
• Allow it to cool for ten minutes.
• Unplug heater and move.
OPERATION
• NOTE: NEVER LEAVE AN OPERATING UNIT UNATTENDED
• With heater in the OFF position ( ), plug the heater into
a polarized 120V outlet. DO NOT FORCE THE POLARIZED
PLUG INTO THE OUTLET; it will only fit one way.
• With 80° oscillation, the Honeywell Ceramic Tower Heater
is versatile and designed to be placed in the center of the
room or closer to the wall (at least 3 feet way) for maximum
convection room heating.
• Turn heater on by pressing the Power Button ( ).The Power
Indicator will illuminate and the heater will start in the
Constant On HI Level Setting ( ).
• The heater has two operational modes – continuous heating
or heating with a thermostat setting where the heater cycles
on and off according to the selected temperature setting.
• To set a Continuous Heat Setting, press ( ): - Choose Low ( ) to use 900 watts of power (750 watts on the HCE317 Series only)
NOTE: Because the Low setting does not require as much electricity to operate, it is more energy efficient and may be a better
option if you are concerned about saving energy.
• In the continuous heat mode, make sure to manually turn the heater OFF when done using this appliance.
• To set the Thermostat, press the Thermostat Control Buttons (
Temperature will flash five times and then the Current Temperature in the room will display as a steady red.
NOTE: If the Current Temperature is higher than your Desired Temperature, the heater will be off until the room temperature falls
below this setting or until the Desired Temperature is changed.
• Press the Timer Button ( ) to select 1, 2, 4, or 8 hour setting. The heater will run for that chosen period in the selected mode,
counting down the hours and automatically shutting the heater off after the selected time has passed.
• Press the Oscillate Button ( ) to to turn on or off the oscillation function.
• To shut the heater off, press the Power Button ( ) and the heater will begin Powering Down. The heater will shut off after counting
down 6 seconds in the Temperature Display to cool down the internal components.
• It is important to allow the heater to run through the cool down phase. DO NOT unplug the heater until it has completed the cool
down cycle.
Fig. 1
Power
Button
Heat Level Settings
Note: Controls/features will vary slightly by model
- Choose High ( ) to use 1500 watts of power
) and choose your Desired Temperature. The Desired
Current Temperature/
Desired Temperature Display
Power
Indicator
Oscillate Button
Timer
Thermostat
Control Buttons
3
Publicidad
