Safety Notes And Precautions; Battery Charger; Charging Procedure - Alpina BT 40 Li 2.0 Manual De Instrucciones

3 green Fully charged battery
lights
2 green Battery is 60% charged
lights
1 green Battery is 30% charged
lights
Battery is 10% charged and
red
needs recharging immediately.

SAFETY NOTES AND PRECAUTIONS

1. DO NOT disassemble the battery.
2. Keep out of the reach of children.
3. DO NOT expose the battery to fresh or salt
water, store it in a cool and dry place.
4. DO NOT place the battery in hot places,
such as near a fire, radiator, etc.,
5. DO NOT switch the negative and
positive battery terminals.
6. DO NOT connect the positive and negative
terminals of the battery to metal objects.
7. DO NOT hit, tap or stand on the battery.
8. DO NOT weld or drill the battery
with nails or other sharp objects.
9. If the battery loses chemicals that come
into contact with your eyes, do not rub
them but rinse thoroughly with water.
10. Stop using the battery if it produces
unusual smells, becomes hot or changes
colour/shape and looks abnormal.
11. If the power cable of this appliance
is damaged, it must be replaced by
the manufacturer or his agent or by
specifically qualified personnel in
order to reduce any resulting risk.
4. ECO-FRIENDLY DISPOSAL
OF THE BATTERY
The following toxic and corrosive
materials are found within the battery
pack used with this tool: Lithium-ion is a
toxic material.
All toxic materials should be
disposed of properly to prevent
environmental contamination.
Before disposing of damaged or broken
lithium-ion battery packs, contact your
local waste disposal agency or the local
Environmental Protection Agency for
specific information and instructions.
Dispose of batteries in a certified lithium-
ion recycling and/or disposal facility.
If the battery pack cracks or breaks,
with or without chemical leakage, do
not recharge or use it. Dispose of and
replace it with a new battery pack.
DO NOT ATTEMPT TO REPAIR IT!
In order to avoid accidents and risks of
fire, explosion or electric shock and to
prevent damage to the environment:
– Cover the battery terminals
with strong adhesive tape.
– DO NOT attempt to remove or destroy
any part of the battery pack.
– DO NOT attempt to open the battery pack.
Electrolytes released from battery
pack chemical leakage are corrosive and
toxic. Do NOT allow chemical substances
to come into contact with eyes, skin
and, above all, do not ingest them.
– DO NOT dispose of batteries
with domestic waste.
– DO NOT burn.
– DO NOT place batteries where they
could become part of a local waste
landfill or municipal solid waste.
– Take them to an authorized
recycling centre.

5. BATTERY CHARGER

SPECIFICATIONS
CG 40 Li
Input: 100-240V ~ 50/60 Hz
Output: 42 V (Nominal)
• The equipment shall not be exposed to dripping
or splashing, and no liquid container, such as
pots, shall be placed above the equipment.
• The charger is designed for rechargeable
lithium-ion batteries. Some other types
of batteries may explode, resulting in
personal injury and property damage.
• Only charge rechargeable batteries.
• The transformer external flexible cable cannot
be replaced; if the cable is damaged, the
whole transformer must be disposed of.
• The line voltage can be disconnected
by pulling the mains socket.
• The socket must be positioned close to
the tool and must be easily accessible.

CHARGING PROCEDURE

NOTE Battery is shipped not fully charged. It
is recommended to charge it before use to ensure
that the maximum operating time is reached.
EN - 3
1.8A