LEGRAND C2G31013 Manual Del Usuario página 6

HDMI® HDBaseT + 3.5mm, USB-B to A, and RS232 over Cat Extender
Box Transmitter to Box Receiver - 4K 60Hz
Features
HDMI 1.4 with 4K@60Hz (chroma sub-sampling 4:2:0 8-bit only) and HDCP2.2 compliant
•
Using a Cat 6a/7 cable, transmit 4K@60Hz (YUV 4:2:0 color sub-sampling) signal up to 40m/130ft
•
and 1080P@60Hz signal up to 70m/230ft
Using a Cat 5e/6 cable, transmit 4K@60Hz (YUV 4:2:0 color sub-sampling) signal up to 35m/115ft
•
and 1080P@60Hz signal up to 60m/200ft
One-way POH, one power adapter is needed to connect to the RX to power both TX and RX
•
USB 2.0 pass-through, one USB Host built in TX and four USB Devices built in RX
•
High-speed USB 2.0 pass-through over HDBaseT up to 70m/230ft
•
One-way analog stereo audio, CEC pass-through and bi-directional RS232 pass-through over HDBaseT
•
Mounting Bracket Installation
Note: Before installation, please ensure the unit is disconnected from the power source.
1. Attach the installation bracket to the enclosure using the screws provided in the package
separately.
2. The bracket is attached to the enclosure as shown.
3. Repeat steps from 1 to 2 for the other side of the unit.
4. Mount and secure the transmitter and receiver to a surface or a suitable location respectively
with mounting screws.
Wiring
Warnings:
Before wiring, disconnect the power from all devices.
•
During wiring, connect and disconnect the cables gently.
•
Steps for device wiring:
1. Connect an HDMI source (such as PC, Blu-ray player, Apple TV, 4K media player, etc) to the HDMI IN of the transmitter using an HDMI cable.
2. Connect a Cat 5e/6/6a/7 cable between the HDBT OUT of the Transmitter to the HDBT IN Input of the Receiver.
3. Connect the HDMI display devices (TV, LED/LCD display, projector, etc.) to the HDMI OUT of the Receiver.
4. Connect for additional control options:
USB: Connect a USB Host device to USB HOST port of the Transmitter, and connect USB devices (such as keyboard, mouse and USB
•
camera) to USB DEVICE ports. The USB devices can be connected to the Host PC.
RS232: Connect a RS232 Master (or Slave) Device to RS232 port of transmitter, and connect a RS232 Slave (or Master) Device to RS232
•
port of receiver (More detail information, please refer to "RS232 Pass-Through" section.
5. Connect the included 12V power supply to the Receiver. The PoH function carries power along the length of the cable one-way to power the
Transmitter. No additional power supply is required for the Transmitter.
6. Power on all devices.
4
Package Contents
1 x Transmitter
•
1 x Receiver
•
1 x 12V Power Adapter
•
4 x Mounting Bracket (with screws)
•
2 x 3.5mm 3-Pin Phoenix Connector
•
1 x Manual
•
(us)
(us)