5. DAILY USE
5.1 Using the hood
Check the recommended speed according to
the table below.
While heating up food, cooking with covered pots.
While cooking with covered pots on multiple cooking zones or
burners, gentle frying.
While boiling and frying big quantities of food without a lid, cooking
on multiple cooking zones or burners.
While boiling and frying big quantities of food without a lid, big hu‐
midity.
It is recommended to leave the hood
operating for approximately 15 minutes
after cooking.
To operate the hood:
1. Press the first speed button
on the appliance.
2. If needed, press the light button
illuminate the cooking surface. The light is
dimmable. Press again the button to
change the intensity from:
a. Maximum,
b. Medium,
c. Low,
d. Off.
3. If needed, change the speed by pressing
the desired button.
To turn off the appliance press the first speed
button
again.
5.2 Hob²Hood function
It is an automatic function which connects the
hob with a hood. Both the hob and the hood
have an infrared signal communicator. Speed
of the fan is defined automatically on basis of
mode setting and temperature of the hottest
cookware on the hob. You can also operate
the fan using the hob manually. The function
can be activated from panel of the hob.
For more information how to use the
function refer to the hob user manual.
5.3 Filter notification
Filter alarm reminds to change or clean the
to switch
charcoal filter and clean the grease filter. The
filter indicator
to
if the grease filter must be cleaned. The filter
indicator
charcoal filter must be replaced or cleaned.
Refer to cleaning the grease filter in care
and cleaning chapter.
Refer to cleaning the charcoal filter or
replacing the charcoal filter in care and
cleaning chapter.
To activate or deactivate function:
1. To activate function press the button
for 3 seconds.
If the function is activated, the filter indicator
flashes two times.
2. To deactivate function press the button
for 3 seconds.
If the function is deactivated, the filter
indicator
64
is turned on for 30 seconds
flashes for 30 seconds if the
flashes ones.