AEG DCK5280HG Manual De Instrucciones página 66

The dishwasher must be set to a low
temperature and a short cycle. The
grease filter may discolour, it has no
influence on the performance of the
appliance.
5. To mount the filters back follow the first
two steps in reverse order.
Repeat the steps for all filters if applicable.
6.3 Cleaning the charcoal filter
To remove the filter:
1. Remove the grease filters from the
appliance.
Refer to "Cleaning the grease filter" in this
chapter.
2. Remove the clips holding the filter bed
(1), then the filter bed (2).
2
7. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem
You cannot activate the appliance.
1
Possible cause
The appliance is not connected to a
power supply or it is connected in‐
correctly.
3. Wash the filter bed in hot water without
using detergent or use a dishwasher.
Set the dishwasher without using rinse
aids or any other detergents. The
dishwasher cannot be filled with dishes.
4. Leave the filter bed to dry or use an oven.
Set the oven for 7 minutes in the
maximum temperature of 60°C.
5. To install the filter, perform the steps in
reverse order. The filter has to be fully
dried before installing it back into
appliance.
Replace the filter bed every 2 years or when
the cloth is damaged.
6.4 Replacing the lamp
This appliance is supplied with a LED lamp.
This part can be replaced by a technician
only. In case of any malfunction refer to
"Service" in the "Safety Instructions" chapter.
Remedy
Check if the appliance is correctly
connected to the electrical supply.
66