Bimar ZHQ1545 Folleto De Instrucciones página 9

Fax +32 030 9904733

The wall to which the heater is attached must be solid
and made of fireproof and heat resistant material (not
of wood or synthetic material or similar). The ceiling
must also be made of fireproof and heat resistant
material (if the heater is placed in a patio, ensure that
the patio roof will not be damaged or set on fire by the
heat emitted). The distances between the heater and the
walls and ceiling of the room as indicated in the
diagram alongside are appropriate for structures made
of the abovementioned materials. Note: the minimum
distance between the bottom of the heater and the floor
must be at least 2m.
Before drilling the holes, ensure:
- that there are no water or gas tubes or electrical cables built into the wall
- that the appliance is in a position where it cannot be bumped
- that the appliance is placed far from other heat sources, flammable objects (curtains, tapestries,
etc), flammable gas or explosive materials (spray cans) and from materials that can be deformed
by heat.
For attachment to the
wall:
- use
provided
illustrated
diagram alongside.
Ensure that the appliance is unplugged from the power point before assembly.
- Place the metal bracket against the wall, trace the 4
holes and drill them (before drilling it is recommended
to measure the spacing of the tracings against the holes
on the bracket), insert the 4 dowels and attach the
bracket to the wall.
- Attach the appliance to the bracket using the 3 screws
and nuts.
- Face the appliance (up/down) in the right direction and
block it using the side screws.
- Check that the electric cable will not come into contact
with heated walls.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
the parts
and
in the
Assembly page 9/28
9 28
/
- 3 screws + 3
nuts
- 4 dowels
- 1 bracket
- 1 wrench
- 1 Allen key