Replacing The Lamp - EuroLite Police Beacon Manual Del Usuario

If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, lamp explosion, crash etc.
Attention: The operation of warning beacons in Germany is permitted only in non-public areas.
Use in public traffic (streets, roads, and plazas) is prohibited!
This prohibition applies also to areas immediately adjoining public traffic, since an endagering of

Replacing the lamp

Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
For the installation, you need one 12 V / 21 W bayonet lamp.
Procedure:
Step 1: Unscrew the screws on the housing exterior.
Step 2: Remove the colour-cap.
Step 3: If replacing the lamp, remove the old lamp from the lamp-socket.
Step 4: Screw the new 12 V / 21 W bayonet lamp into the lamp-socket.
Step 5: Replace the colour-cap and tighten the screws.
the traffic flow cannot be excluded!
DANGER TO LIFE!
Only install the lamp with the device switched off!
Unplug from mains before!
CAUTION!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
Do not operate this device with opened colour-cap!
10/19 00051158.DOC, Version 1.2