Publicidad
Idiomas disponibles
Idiomas disponibles
1. PROPERTIES OF THE PRODUCT
The purpose of the chain sawing machine is to be used in household tasks. The sawing machine is meant exclusively to cut wood.
Since the sawing machine is equipped with a combustion engine, it must be operated in open areas or in adequately prepared
interiors. The sawing machine may also be used to fell trees, but due to the danger involved, it is required it is operated by an
experienced user. A correct, reliable and safe functioning of the device depends upon its adequate operation, and therefore:
Before you proceed to use the tool, read the whole manual and keep it.
The supplier shall not be held responsible for any damage and injuries caused by operation of the tool other than intended, failure
to observe safety regulations and recommendations of this manual. Operating of the tool for purposes other than intended shall
also render the warranty void.
2. EQUIPMENT
The sawing machine is delivered complete, but before first operation it requires assembly.
Along with the sawing machine the following elements are supplied:
- chain guide
- cutting chain
- protection of the guide
3. TECHNICAL DATA
Parameter
Catalogue number
Weight
Fuel tank capacity
Chain lubrication oil tank capacity
Cutting length
Chain scale
Guide link length
Chain type
Chain guide type
Maximum chain speed
Number of sprockets of the chain driving wheel and scale
Motor
Number of cylinders
Strokes
Cooling
Type of spark plug
Motor swept capacity
Motor power
Maximum acceptable rotational speed of the motor with the cutting system
Recommended idle rotational speed
Fuel consumption at the maximum motor power
Unitary fuel consumption at the maximum motor power
Noise
Acoustic pressure
L
power
wA
Vibration level - front / rear handle
4. GENERAL SAFETY CONDITIONS
WARNING! During operation of a gasoline, it is recommended to always observe the basic safety regulations including those
mentioned below, in order to diminish the risk of fire, electric shock and injury.
Before operation of the tool can be commenced, the whole manual must be read and kept.
ATTENTION! Read all the instructions mentioned below. If they are not observed, there is a risk of electric shock, fire or injury.
The notion of „gasoline tool" that is used in the instructions refers to all tools that are powered with a stream of compressed air
O R I G I N A L
GB
Measurement unit
[kg]
[cm
3
]
[cm
]
3
[mm]
[cm]
[mm]
[m/s]
[cm3]
[kW]
[min
-1
]
[min
]
-1
[kg/h]
[g/kWh]
[dB (A)]
[dB (A)]
[m/s2]
I N S T R U C T I O N S
Value
YT-84900
5,2
560
260
44
8,255
1,47
21LP-72X / 21LPX72E, Oregon
188PXBK095, Oregon
21
7 sprockets x 8,255 mm
1
2
air
L8RTF, BM6A
45
1,8
11 000
3000 ± 400
0,640
480
90,8 ± 2,5
109,3 ± 2,5
6,815 ± 1,5 / 5,277 ± 1,5
17
Publicidad
