User Manual - Velleman VTSSC50N Manual Del Usuario

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could
harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it
should be taken to a specialized company for recycling. This device should be returned to your
distributor or to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into service. If
the device was damaged in transit, don't install or use it and contact your dealer.
2. Safety Instructions
Warning: this tool must be placed on its stand when not in use; do not leave the tool
unattended when switched on.
Incorrect use of this tool may cause fire.
Be cautious when using this tool in places where inflammable products are stored.
Heat can cause fire to inflammable products even when they are not in sight.
Do not use the tool in an explosive atmosphere.
Place the tool back in its stand in order to let it cool down before storage.
3. Features
manual temperature setting
power-on LED indication
with on/off switch
ceramic heating element
with stand for left- or right-handed use
standard tip (incl.): BITC50N2 (1.0 mm).
4. Operation
Verify whether the operating voltage of the unit is compatible with the mains voltage prior to plugging in
this device.
Make sure that the device was not damaged in transit.
Use the rotary control on the front panel to set the desired temperature.
5. Common Causes for Tip Failure
The tip is not sufficiently tinned.
Wiping the tip on a surface with high sulphur content or on a dirty or dry sponge or rag.
Contact between the tip and organic or chemical substances such as plastic, silicone, grease, etc.
Impurities in the solder and/or solder with a low tin content.
Note: The heating element may be damaged when its temperature reaches 430 °C (806 °F).
6. Important Remarks
Remove and clean the tip after heavy or moderate use. We recommend cleaning the tip every day if the
device is used on a daily basis. Clear excess solder from the tip assembly.
The supplied soldering tip is made of iron-clad copper and will retain its projected life span if used properly.
Always tin the tip before returning it to the holder, prior to deactivating the station or in case of long
periods of inactivity. Clean the tip with a wet sponge prior to use.
Do not use temperatures over 400 °C (750 °F) as this will shorten the life span of your tip.
Do not exert too much pressure on the tip while soldering to avoid damage.
Never clean the tip with a file or other abrasive materials.
V. 04 – 06/02/2013
VTSSC50N

USER MANUAL

2 ©Velleman nv