Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
adjusted the rod, re-tighten the clip. Fig. 4
Insert the upper rod (a) into the hole at the bottom of the collar section of the hanger.
3.
Fig. 5
Insert the non-drip protector into the lower rod (c). Fig. 6
4.
Insert the above assembly into the hole on the surface of the motor unit as shown in
5.
Figure 7.
Fix the balloon for top garments to the mounting flange and make sure that no air leaks
6.
from the bottom. The seam of the balloon should coincide with the centre of the edge of
the motor unit as much as possible. Fig. 8-9
7.
Dress the balloon with the garment (as shown in Figure 10) and ensure the following:
-
The collar of the garment is well positioned.
-
That the buttons (if the garments has any) are centred on the front of the balloon.
-
The arms of the balloon fit with the sleeves of the garment and do not wrinkle or twist.
-
The garment is fully buttoned.
Warning
Make sure the balloon is well fixed to the mounting flange and that there are no air leaks.
Assembly for bottom garments
1.
Remove the hanger and collar section assembly. Fig. 11
2.
Loosen the height-adjustment clip and pull the upper rods (a) to adjust the height. Once
the desired height has been set, re-tighten the clip. Fig. 12
3.
Insert the lower rods (b) into the Y-shaped bracket. Fig. 13
Insert the support rod (c) into the bottom of the Y-shaped bracket. Then insert the
4.
non-drip protector into the support rod (c). Fig. 14-15
Insert the above assembly into the hole on the surface of the motor unit as shown in
5.
Figure 16.
Fix the balloon for bottom garments to the mounting flange and make sure that no air
6.
leaks from the bottom. The seam of the balloon should coincide with the centre of the
edge of the motor unit as much as possible. Fig. 17-18
7.
Dress the balloon with the bottom garment and make sure it fits well and does not twist
or wrinkle. All buttons and zips (if there are any) must be fastened. Fig. 19
Warning
Make sure the balloon for bottom garments is well fixed to the mounting flange and that there
are no air leaks.
Using the counterweight clamps
The counterweight clamps help to better stretch the garment vertically for improved
1.
ironing.
38
IRONHERO 1200 MANNEQUIN DRY
Publicidad
