Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Where to install the tumble dryer
EN
• Install the dryer far from gas
ranges, stoves, radiators or
hobs, as flames may damage
it. The dryer should be installed
in an ambient room tempera-
ture of between 20 to 23°C for
optimum performance. But will
function if the room is between
14 and 30°C.
If the dryer is installed below a
worktop, ensure there are 10 mm between the upper panel
of the dryer and any objects above it, and 15 mm between
the sides of the machine and the walls or furniture units
adjacent to it. This ensures adequate air circulation.
Ventilation
• The room must be adequately ventilated while the dryer is
running. Make sure that the dryer is installed in a room free
of humidity and with adequate air circulation. The flow of air
around the dryer is essential to allow water to condense du-
ring drying; the dryer will not function properly if it is placed
in an enclosed space or inside a cabinet.
!
Some condensation may form if the dryer is used in a small
or cold room.
!
We do not recommend that the dryer is installed in a
cupboard but the dryer must never be installed behind a
lockable door, a sliding door or a door with a hinge on the
opposite side to that of the dryer door.
Water drain
If your dryer is installed next to a drain the water can be
plumbed into this drain. This does away with the need to
empty the water container. If the dryer is stacked onto or
installed next to a washing machine it can share the same
drain. The height of the drain must be less than 3' (1 m)
from the bottom of the dryer. Remove existing hose from
position shown in picture A and fit a suitable length of hose
and connect as shown in picture B.
!
Make sure that the hose is not squashed or kinked
when the dryer is in its final location.
Picture A
36
15 mm
15 mm
15 mm
15 mm
Picture B
Electrical connections
Before plugging the appliance into the socket, check the
following:
• Make sure your hands are dry.
• The socket must have an earth connection.
• The socket must be able to withstand the machine's
maximum power output as indicated on the data plate (see
Description of the tumble dryer).
• The power supply voltage must fall within the values indi-
cated on the data plate (see Description of the tumble dryer).
• The socket must be compatible with the machine's plug. If
not, either the socket or the plug must be replaced.
!
Do not use extension cords.
!
The tumble dryer must not be installed in outdoor spaces,
even if sheltered. It may be very dangerous to expose this
appliance to rain and thunderstorms.
!
Once dryer installation is complete, the electric cord and
plug must be at hand.
!
The electric cord must not be bent or crushed.
!
If the plug to be replaced is of the moulded-on type, it
must be disposed of in a safe way. DO NOT leave it where it
can be plugged into a socket and cause electric shocks.{}
!
The electric cord must be regularly checked and replaced
with a cord specifically designed for this dryer; it must then
be installed by an authorised technician only (see Assistan-
ce). New or longer electric cords are supplied by authorised
dealers at a supplementary cost.
!
The manufacturer declines all responsibility for failure
to observe these instructions.
!
When in doubt about the above indications, contact a
qualified electrician.
Levelling the tumble dryer
The dryer must be installed level for correct operation.
When you have installed your dryer in its final location check
that it is level first side-to-side, then front to back. If the dryer
is not level, adjust the two legs up or down until your dryer
is level.
Preliminary information
Once the tumble dryer is installed, clean the inside of the
drum before operating it and remove any dirt accumulated
during transportation.
Warning ! Before you use your dryer ensure that its has
been in a upright position for at least 6 hours.
Publicidad
