Publicidad
Idiomas disponibles
Idiomas disponibles
UNPACKING YOUR ICE MAKER
1. Remove the exterior and interior packaging. Check if ice basket and ice scoop inside. If
any parts are missing, please contact our customer service.
2. Remove the tapes for fixing ice shovel, ice basket & ice scoop. Clean the tank & ice
basket.
3. Put the ice maker on a level & flat counter top without direct sunlight and other sources of
heat (i.e.: stove, furnace, radiator). Make sure that there is at least 4 inches gap between
the back & LH/RH sides with the wall.
4. Allow one hour for the refrigerant fluid to settle before plugging the ice maker in.
5. The appliance must be positioned so that the plug is accessible.
WARNING: fill with potable water only. Only use drinking water.
ASSEMBLE HANDLE
Rotate the handle to the same angle as the mounting hole on the machine, Put It on the
machine.
CONNECTING YOUR ICE MAKER
*Improper use of the grounded plug can result in the risk of electrical shock. If the
power cord is damaged, please call our customer service.
1. This unit should be properly grounded for your safety. The power cord of this appliance is
equipped with a three-prong plug which mates with standard three prong wall outlets to
minimize the possibility of electric shock.
2. Plug your appliance into an exclusive, properly installed, grounded wall outlet. Do not
under any circumstances, cut or remove the third (ground) prong from the power cord.
Any questions concerning power and/or grounding should be directed toward a certified
electrician.
3. This appliance requires a standard 220-240Volt, 50Hz electrical outlet with good
grounding means.
!
DANGER
7
Publicidad
