Alsafix D 38/100 P1 Manual De Operaciones página 13

1. BEFORE OPERATION
Wear safety glasses or goggles
Do not connect the air supply
Inspect screw tightness
Check operation of the contact arm and trigger if moving smoothly
Connect the air supply
Check the air-leakage (the tool must not have the air-leakage)
Hold the tool with finger-off the trigger, the push the contact arm against the work-piece
(the tool must not operate)
Hold the tool with contact arm free from work-piece and pull the trigger (the tool must not operate)
DISCONNECT THE AIR SUPPLY
2. OPERATION
Wear safety glasses or goggles danger to the eyes always exists due to the possibility of dust being
blown up by the exhausted air or of a fastener flying up due to the improper handling of the tool. For
these reasons, safety glasses or goggles shall always be worn when operating the tool.
The employer and/or user must ensure that proper eye protection is worn. Eye protection equipment
must provide both frontal and side protection.
The employer is responsible to enforce the use of eye protection equipment by the tool operator and
all other personnel in the work area.
NOTE : Non-side shielded spectacles and face shields alone do not provide adequate protection.
Keep hands and body away from the discharge outlet when driving the fasteners because of dange-
rous or hitting the hands or body by mistake.
Warning :
Do not touch the trigger and do not place the lever on the counter or on the ground.
Do not aim the discharge opening toward a person.
INSTRUCTIONS FOR OPERATION
Read section titled "SAFETY INSTRUCTIONS"
13