Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INSTRUCTIONS
WARNING : to avoid severe personal injury or property damage.
Before using the tool, read carefully and understand the following "safety instructions". Failure to follow
warnings could result in death or serious injury.
PRECAUTIONS ON USING THE TOOL
1. Wear safety glasses or goggles.
Danger to the eyes always exists due to the possibility of dust being blown up by the exhausted air or
of a fastener flying up due to the improper handling of the tool. For these reasons, safety glasses or
goggles shall always be worn when operating the tool.
The employer and/or user must ensure that proper eye protection is worn. Eye protection equipment
must provide both frontal and side protection.
The employer is responsible to enforce the use of eye protection equipment by the tool operator and
all other personnel in the work area.
NOTE : Non-side shielded spectacles and face shields alone do not provide adequate protection.
2. Ear protection may be required in some environments.
As the working condition may include exposure to high noise levels which can lead to hearing damage,
the employer and user should ensure that any necessary hearing protection is provided ans used by
the operator and others in the work area.
3. Do not use any power source except an air compressor.
The tool is designed to operate on compressed air. Do not operate the tool on any other highpressure
gas, combustible gases (e.g., oxygen, acetylene, etc.) since there is the danger of an explosion. For
this reason, absolutely do not use anything other than an air compressor to operate the tool.
4. Operate within the proper air pressure range.
The tool is designed to operate within an air pressure range of 5 to 7 bars. The pressure should be
adjusted to the type of the work being fastened. The tool shall never be operated xhen the operating
pressure 8 bars.
Never connect the tool to air pressure which potentially exceeds 14 bars as the tool can burst.
5. Do not operate the tool ear a flammable substance.
Never operate the tool near a flammable substance (e.g., thinner, gasoline, etc.). Volatile fumes from
these substances could be drawn into the compressor together with the air and this could result in an
explosion.
6. Do not use a wrong fittings.
The connector on the tool must not hold pressure when air supply is disconnected. If a wrong fitting is
used, the tool can remain charged with air after disconnecting and thus will be able to drive a fastener
even after the air line is disconnected, possibly causing injury.
7. Disconnect the air supply and empty the magazine when the tool is not in use.
Always disconnect the air supply from the tool and emply the magazine when operation has been com-
pleted or suspended, when unattended, moving to a different work area, adjusting, disassembling, or
repairing the tool, and when clearning a jammed fastener.
9
Publicidad
