Publicidad
Idiomas disponibles
Idiomas disponibles
Before performing cleaning, adjusting, repairing and
maintenance tasks, always unplug the power cord.
Replace worn out or damaged parts immediately, so that
the power tool is always in a safe operating condition.
Cleaning:
The power tool should be thoroughly cleaned thoroughly
after each use.
Do not use aggressive cleaning products. These products
may damage plastics and metals, compromising the safe
operation of the power tool.
Maintenance:
Only maintenance works described in this instruction
manual may be carried out, all other works must be
performed by an official dealer.
Keep all nuts and bolts tight so the power tool is in safe
operating condition.
If any components or safety devices are removed for
maintenance
works,
immediately and correctly.
Use only VITO-approved accessories for this device or
technically identical parts. Failure to do so may result in
personal injuries or damages to the nail/staple gun. If in
doubt, if you lack knowledge or resources, you should
contact an official dealer.
Your nail/staple gun should only be serviced by the
manufacturer's internal service personnel, or other
qualified personnel, replacing any necessary parts with
original parts.
they
must
be
repositioned
This machine is intended for stapling and/or nailing
cardboard, insulation material, fabrics, sheets, leather and
similar materials on wooden or wood-like surfaces.
When working with the nail/staple gun, there are a number
of precautions and procedures you should be aware of:
▪ When working on loose parts, use clamping devices to
fix parts securely and stably;
▪ Do not press the nail/staple gun head by hand;
▪ Do not use the nail/staple gun to tie up electrical cables;
▪ Adopt a working procedure so that the power cord is
always behind the nail/staple gun during operation;
▪ Switch off the device immediately if any of the following
problems occur:
- Sparks on the carbon brushes and smoke is coming
out;
- Grease leaking from the ventilation slots;
- Damage on the housing;
- Damage on the ON/OFF switch.
Publicidad
