LYTEQUEST Xperformer Bar Manual Del Usuario página 7

REMOTE CONTROL
DMX ADDRESS SETTING
The DMX mode allows the use of a universal DMX controller.
Each element requires a « star address » of 1-512.
A fixture that requires one or more control channels starts reading data on the channel
indicated by the starting address. For example, a fixture that occupies or uses 7 DMX
channels and has been addressed to start on DMX channel 100, would read data from
channels: 100, 101, 102, 103, 104, 105 and 106. Choose a starting address so that the
channels used do not overlap. E.g. the next unit in the chain starts at 107.
DMX CHANNELS
CHANNEL VALUE
0-10
11-50
51-100
CH1
101-150
151-200
201-255
210-255
CH2 0-255
CH3 0-255
CH4 0-255
CH5 0-255
CH6 0-255
CH7 0-255
CH8 0-255
12
ON / OFF
A1: Effet 1 Tout allumé
A2: Effet 2 Changement de couleur par sauts A3:
Effet 3: Changement progressif
A4: Ac�va�on par le son
A5: Stroboscope
Color: Réglage de couleur
Speed: Réglage de vitesse
DMX: Sélec�on du canal DMX
IP: Effet chenillard
DESCRIPTION RECALL
No function
Macro A1
Macro A2
Macro func�on
Macro A3
Macro A4
Macro A5
Red+Green+Blue
Macro Color
Speed setting
General dimmer
Red Dimmer
Green dimmer
Blue Dimmer
White dimmer
LES COMBINAISONS
VALUE
A1.01
All colors (Red, Green, Blue, UV) + Astro Mode
A1.02
Red color
Green color
A1.03
A1.04 Blue color
A1.05 Green / Red colors
Green / Blue colors
A1.06
Red / Blue colors
A1.07
A1.08 UV + Astro Mode
A1.09 Red / Green colors
Colors Red / Green
A1.10
Colors Red / UV + Astro Mode
A1.11
Colors Green / Blue
A1.12
A1.13 Colors Green / UV + Astro Mode
Colors Blue / UV + Astro Mode
A1.14
Colors Green / Red / UV + Astro Mode
A1.15
Colors Red / Blue / UV + Astro Mode
A1.16
A1.17 Colors Green / Blue / UV + Astro Mode
A1.18 Green / Red / Blue permanent colors
FAILURE DIAGNOSIS
Problem
1. Check power connection
No display when powering on
2. Check if the plug works
1. Check if the DMX address has been set correctly
Light is uncontrollable
2. Check if the DMX cable is correctly connected
1. Check if the sensor is soldered to the PCB
Light goes out after a while
2. Check if the temperature is too high
3. Check if the power supply is working
The beam is very dark
1. Check if the temperature is too high and causes a too fast fade
2. Check if the lamp glass is clean
EFFECTS
Solu�on
13