Sagem PHOTO EASY 160 Manual Del Usuario página 38

Liasse AZUR_GB.book Page 34 Jeudi, 21. avril 2005 4:09 16
12 M
AINTENANCE
C
LEANING THE PRINT HEAD
Continuous lines across the length of your photographs may be caused by dirt
particles stuck to the printhead.
You will need a methylated alcohol
off-the-shelf cotton tips ("Q-tips").
Switch off your printer, disconnect the main cables and wait for five minutes;
since the print head operates at a high temperature, there is a risk of burning
if you touch it.
1 - Open the cartridge flap. Press on the locking lever and pull out the film
cartridge.
2 - Pull out the paper tray.
3 - Turn the printer upside down to remove the lower hatch.
4 - Clean the heating line of the print head carefully using a cotton bud.
5 - Replace the lower hatch, turn the printer right side up, connect the mains
cable and switch on the printer.
Warning :
Never touch the print head with your fingers or any object that might scratch it.
1
4
Replace the film cartridge. Take care that the film is taut before inserting the
cartridge into its compartment. Check that the locking lever is pushed down
correctly and close the flap.
Push the paper tray back into place until the locking system clicks.
1. Do not use corrosive chemicals, they may damage your printer.
1
based cleaning product and some
2
- 34 -
3
5