Uline H-7942 Manual Del Usuario

H-7942
8' RECYCLED PLASTIC
BENCH WITH BACK
TOOLS NEEDED
Power Drill
Double Holed Bullnose
8' Bench Slat x 2
Figure 1
PAGE 1 OF 6
1-800-295-5510
uline.com
7/16" Socket Bit
Single Hole 8' Bench Slat x 5
PARTS
Bench Base x 4
ASSEMBLY
NOTE: It is important to keep screws loose
throughout assembly. Tighten during step 7.
1. Verify all parts are present before beginning.
2. Place the four bench bases on a flat, level surface.
3. Align a double holed bullnose bench slat on the
front set of pre-drilled holes on the bench base seat.
Loosely attach bench slat to the bench bases with
the 3½" lag screws and washers using the power drill
and 7/16" socket bit (will tighten later in step 7).
(See Figure 1)
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Washers x 36
3⁄" Lag Screws x 36
0621 IH-7942