Publicidad
Idiomas disponibles
Idiomas disponibles
Getting Started
Before first use, the battery
y
according to the diagram in the figure.
Install the battery
(11)
into the battery compartment (14).
y
A pictogram in the form of a "dot" on the battery should be
on the left. You will hear a click when the battery is placed
correctly.
Open the lens covers (2).
y
Press the ON/OFF button
y
on.
Adjust the interpupillary distance by moving the eyepieces
y
(13)
farther or closer to each other. It takes some effort to
move the eyepieces.
Adjust the symbol sharpness on the displays by rotating
y
the eyepiece dioptre rings (12). In future, it will not be
necessary to rotate the eyepiece dioptre rings, regardless
of the distance and other conditions.
To focus on the object being observed rotate the lens
y
focusing ring (10).
Select the calibration mode: manual (M), semi-automatic
y
(SA) or automatic (A) in the main menu (enter the menu by
long pressing the MENU button (9).
Calibrate the image with a short press of the ON/OFF
y
button
(4)
(when calibration mode (SA) or (M) has been
selected). Close the lens cap before manual calibration.
Select the required amplification level ("Normal", "High",
y
"Ultra") by briefly pressing the DOWN button (8).
(11)
should be charged
(4)
briefly to power the device
Activate the smoothing filter
y
improve the thermal image as the amplification level
increases.
Select one of the colour palettes in the main menu (for
y
more details, see the Interface –> Main Menu –> Colour
Modes section of the full version of the manual).
Adjust the brightness, display contrast, smooth digital
y
zoom in the quick menu (activate by briefly pressing the
MENU button (9).
Briefly press the LRF button
y
The rangefinder reticle will appear in the centre of the
image. Press and hold down the LRF button
seconds to measure the distance in scan mode. If the
rangefinder is idle longer than for 4 seconds, it turns off
automatically.
After use, press and hold down the ON/OFF button
y
turn the device off.
Notes:
To prevent accidental decamouflage of the user, the
y
displays automatically turn off when the observer moves
the device away from the face.
When the device approaches the face, the displays will
y
automatically turn on.
The proximity sensor can be disabled/enabled in the
y
"General settings" section of the main menu.
in the main menu to
(6)
to measure the distance.
(6)
for 2
(4)
to
English
13
Publicidad
