Glacier bay 21-K153KCP-GB Guía De Instalación Y Cuidado página 6

Installation (continued)
3
Installing with the optional deck plate
□ Apply a thin bead of silicone to the underside of the gasket (C).
□ Place the gasket (C) and deck plate (B) over the mounting
holes in the sink, aligning the center holes in the gasket
(C) and deck plate (B) with the center mounting hole in the
sink.
□ Carefully insert the water supply lines (D), spray hose (E)
and quick-connector (F) on the faucet body (A) through the
hole in the deck plate (B) and the mounting hole in the sink
until the faucet sits on top of the deck plate (B).
B
5
Adding the weight to the spray hose
□ Loosen the cover on the weight (G) and slide it onto the
spray hose (E) until it is positioned at the location marked
"weight here".
□ Hand tighten the cover on the weight (G) by turning it in a
clockwise direction.
1
2
A
C
F
D
E
G
E
4
Securing the faucet
□ From underneath the sink, secure the faucet body (A) to the
sink by sliding the rubber washer (CC), metal washer (BB),
and FastMount (AA) over the water supply lines (D), spray
TM
hose (E) and quick-connector (F), and onto the shank on
the faucet body (A).
□ Push the FastMount
firmly against the underside of the sink and turn to tighten.
Do not overtighten.
NOTE: It is helpful to have a second person hold the faucet
in place while tightening the FastMount
A
CC
BB
6
Attaching the spray hose
□ The quick-connector (F) is preassembled onto the outlet hose.
□ Attach the quick-connector (F) by pushing it onto the end of
the spray hose (E).
NOTE: If it is necessary to disconnect the spray hose (E)
from the faucet, squeeze the tabs on the quick-connector
(F) and pull down to disconnect.
6
(AA) upwards until it is pressed
TM
.
TM
F
AA
D
E
F
E
E