Hitachi Koki DS 14DFL Manual De Instrucciones página 16

English
Loosen
(b) Remove the hook and spring (Fig. 9).
Hook
(c) Install the hook and spring on the other side
and securely fasten with screw (Fig. 8).
NOTE:
Pay attention to the spring orientation. Install the
spring with larger diameter away from you (Fig.
10).
Screw
Larger diameter faces away
2. Using the bit holder (Hook with bit holder)
Installing the bit
Slide the bit from the side, and then insert firmly
until the groove on the bit locks in the protruded
section of the hook.
Removing the bit
Securely hold the main unit and pull out the bit by
holding the tip with your thumb (Fig. 11).
16
Screw
Fig. 8
Spring
Fig. 9
Fig. 10
CAUTION:
●
Only Hitachi STANDARD ACCESSORIES phillips
bit (No. 2 × 65L; Code No. 983006) may be used.
Do not use other bits since they may come loose.
2. Using the bit holder.
CAUTION:
●
Stow the bit in the specified location on the tool.
If the tool is used with the bit stowed improperly,
the bit may fall and cause bodily injury.
●
Do not stow bits that are of a different length,
gauge or dimension than the plus driver bit
(65 mm long) included in the STANDARD
ACCESSORIES.
The bit may fall and cause bodily injury.
(1) Removing the bit
Securely hold the main unit and pull out the bit by
holding the tip with your thumb (Fig. 12).
Bit
(2) Installing the Bit
Install the bit with steps opposite of when
removing. Insert the bit so that the right and left
sides are equal, as shown in Fig. 13.
Fig. 11
Fig. 12
Insert so that
bit does not
protrude
from main unit
Fig. 13