ZKTeco C9AP Serie Guía Rápida página 10

Step 3: Install the Floodlight Camera
1.
Remove the protective film from the dust pad, and then stick it on the
bottom of the camera by inserting the wires through the center of the dust
pad.
2. According to the following wiring diagram, connect the same wires to the
corresponding wire ports. Make sure to tighten the screws.
To avoid corrosion, tighten the central screw by putting it into the camera
3.
centre. Then, using the central screw cap, cover the centre screw
1
3
Step 4: Adjust the Camera and Power on
1.
Turn the knobs to adjust the angle of floodlight and lens as required.
2. Switch on the power at the circuit breaker or fuse box, and then check
whether the device is wired properly.
2
9