Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Steps of European/Australian
Standard
Brown: Live
Wire (L)
Mounting
Anchors
Blue: Neutral
Wire (N)
Junction Box
Note: The existing wires are required to install the camera.
Step 1: Remove the Existing Floodlight
1.
Turn off the power at circuit breaker or fuse box.
2.
Check with an electric tester to make sure that the power is switched off
before the installation.
3.
Remove the existing floodlight and pull it out from the wall to reveal the wires.
Step 2: Install the Junction Box
1.
Drill two holes in the wall according to the hole positions of the junction
box, and then insert the plastic anchor into the holes. Anchors are
necessary for walls that are made of hard materials such as concrete, brick
or stucco.
2.
Fix the junction box on the wall with the proper provided screws.
1
Yellow & Green:
Ground Wire (E)
Mounting
Adjustment Knob
Screws
Installation Diagram - EU/AUS
Dust Pad
Lock Collar
8
Central
Central
Screw
Screw Cap
2
Publicidad
