Makita HM1802 Manual De Instrucciones página 4

Symbols
The followings show the symbols used for tool.
volts
amperes
hertz
alternating current
Class II Construction
revolutions or reciprocation per minute
number of blow
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Switch action
CAUTION:
• Before plugging in the tool, always check to
see that the switch lever actuates properly and
returns to the "OFF" position when released.
1
► 1. Switch lever
To start the tool, simply squeeze the switch lever.
Release the switch lever to stop.
For model HM1812 only
NOTE:
• Blows at no load per minute becomes smaller than those
on load in order to reduce vibration under no load, but this
does not show trouble. Once operation starts with a bit
against concrete, blows per minute increase. When tem-
perature is low and there is less fluidity in grease, the tool
may not have this function even with the motor rotating.
Indicator lamps
1
2
► 1. Power-ON indicator lamp (green) 2. Service
indicator lamp (red)
The green power-ON indicator lamp lights up when the tool is
plugged. The indicator lamp is lit but the tool does not start even
if the tool is switched on, the carbon brushes may be worn out, or
the controller, the motor or the ON/OFF switch may be malfunc-
tion. The red service indicator lamp flickers up when the carbon
brushes are nearly worn out to indicate that the tool needs servic-
ing. After some period of use, motor will automatically be shut off.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing soft grip
1
► 1. Soft grip 2. Bolt
Soft grip is NOT installed before factory shipment.
Install soft grip securely.
4 ENGLISH
2