Poulan Pro PP325 Manual De Instrucciones página 8

Ocultar thumbs Ver también para PP325:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

KNOW YOUR UNIT
READTHIS INSTRUCTION MANUAL AND SAFETY RULESBEFORE OPERATING YOUR UNIT
Compare the illustrations with your unit to familiarize yourself with the location of the various controls
and adjustments.
Save this manual for future reference.
T_mmer
Head
Muffler
_'_
_
Shaft
Handlebar
Line Limiter/"
Shield
X4_
Throttle
Trigger
Blade
Blade
ON/OFF
SWITCH
The ON/OFF
switch
is located on the trigger
handle and is used to stop the engh_e. Move the
switch to the OFF position to stop the engine.
PRIMER
BULB
The PRIMER BULB removes
air from the car-
buretor and fuel lines and fills them with fuel.
This allows you to start the engine with fewer
pulls on the starter rope. Activate
the primer
bulb by pressing
it and allowing
it to return to
its original form.
Primer Bulb
Start Lever
Starter Handle
START
LEVER
The START LEVER helps to supply fuel to the
engine to aid in starting. Activate
the starting
system by moving the start lever to the START
position. DO NOT squeeze
the throttle trigger
until the engine has started and runs, After the
engine
starts, allow the engine to warm-up
10-15 seconds, then fully squeeze the throttle
trigger to deactivate the starting system.
COUPLER
The
COUPLER
enables
optional
attach-
ments to be installed
on the unit.
BEFORE
STARTING
ENGINE
_
WARNING:
Be sure to read the fuel
information
in the safety rules before you be-
gin. If you do not understand
the safety rules,
do
not
attempt
to
fuel
your
unit.
Call
1-800-554-6723,
FUELING
ENGINE
_
WARNING:
Remove fuel cap slowly
when refueling.
HELPFUL
TIP
I
To obtain the correct oil mix
I
p_ ratio,
pour 3.2 ounces
of
I
'/ 2-cycle
synthetic
oil into
I
one gallon of fresh gas.
I
This
engine
is certified
to operate
on un-
leaded
gasoline,
Before
operation,
gasoline
must be mixed with a good quality synthetic
2-cycle
air-cooled
engine oil designed
to be
mixed at a ratio of 40:1. Poulae/WEED
EATER
brand synthetic oil is recommended,
Mix gaso-
line and oil at a ratio of 40:1. A 40:1 ratio is ob-
tained by mixing 3.2 ounces
(95 ml) of oil with 1
gallon (4 liters) of unleaded
gasoline.
DO NOT
USE automotive
oil or marine oil These
oils
will cause engine damage, When mixing fuel,
follow instructions
printed on container.
Once
oil is added to gasoline,
shake container
mo-
mentarily
to assure that the fuel is thoroughly
mixed,
Always
read and fotlow
the safety
rules relating to fuel before fueling your unit.
IMPORTANT
Experience indicates that alcohol blended fuels
(called gasohol or using ethanol or methanol)
can attract moisture which leads to separation
and formation of acids during
storage, Acidic
gas can damage the fuel system of an engine
while in storage.
To avoid engine problems,
empty the fuel system
before storage for 30
days or longer. Drain the gas tank, start the en-
gine and let it run until the fuel lines and carbure-
tor are empty, Use fresh fuel next season. Nev-
er use engine or carburetor cleaner products in
the fuel tank or permanent damage may occur.
See the STORAGE
section for additional
in-
formation.

Publicidad

Tabla de contenido
loading

Tabla de contenido