Weber GENESIS II SE-330 Manual Del Propietário página 15

Igniting the Side Burner
Using the Electronic Ignition to
Ignite the Side Burner
If one or more of the main burners on your grill are
already lit and you would like to ignite the side burner,
skip to step 3. If none of the main burners are lit and
you are only using the side burner, start with step 1.
1) Check that the side burner control knob is in the
off position. Check by pushing in and turning
knob clockwise (A). Also check that all main burner
control knobs are in the off position.
2) Turn the gas supply valve on.
3) Open the side burner lid (B).
4) Push in and turn side burner control knob
counterclockwise to start/high
5) Push and hold in the electronic ignition button (D).
You will hear the igniter clicking. Check that the side
burner is lit. The side burner flame may be difficult
to see on a bright sunny day.
6) Once side burner is ignited, continue turning the
knob counterclockwise until you reach the desired
position.
7) If the side burner does not ignite within 4 seconds,
turn side burner control knob to the off
and wait five minutes to allow the gas to clear
before attempting to light the burner again.
Should the side burner fail to ignite using the
electronic ignition, refer to the TROUBLESHOOTING
section. There you will find instructions on igniting the
side burner with a match to help determine the exact
problem.
To Extinguish Side Burner
1) Push side burner control knob in and then turn
clockwise all the way to the off
2) Turn gas supply off at the LP tank.
WARNING: Open side burner lid during ignition.
m
WARNING: Do not lean over side burner while
m
igniting or cooking.
WARNING: If ignition does not occur within
m
four seconds of attempting to light the side
burner, turn the burner control knob to
the off position. Wait five minutes to allow
accumulated gas to dissipate, and then repeat
the lighting procedure.
position (C).
B
position
position.
D
15