Publicidad
Idiomas disponibles
Idiomas disponibles
1. AUDIO PLAYER WITH BUILT IN BLUETOOTH RECEIVER AND 6 OPERATING BUTTONS:
MODE: short press switch between USB, SD and bluetooth source. Long press turn ON
the audio player. [
[
] short press folder selection. Long press TWS function. [
select randomplay, scan play, and repeat function. Long press EQ interface. [
Short press title or folder selection. Long press fast forward and fast reverse.
2. MEMORY CARD SLOT. For inserting an SD (HC) card.
3. INFRARED SENSOR FOR THE REMOTE CONTROL. When pressing a button, always
direct the remote control towards the sensor. There must be no obstacles between
remote control and the sensor.
4. USB PORT for connecting a USB storage device.
5. VOLUME Turn the knob left to reduce the volume, turn right to increase. Press to enter.
Short press the EQ interface, Turn the knob to selet the frequency and short press to
confirm and edit.
6. ANTENNA INPUT BNC jacks for connecting the receiving antennas.
7. LEVEL CONTROLS To mix the wireless microphone signals to the other signals. The
LEDs light when a radio signal is received.
8. ON / OFF switch to turn on and off the receiver module.
9. LEVEL CONTROLS To mix the signals of channels 1/2 to the master signal.
10. MIC / LINE LEVEL SWITCH Switch channel 1/2 to microphone level. When the button is
released the input is setting to line level.
11. HI Z LEVEL SWITCH To switch channel 2 to high impedance instrument level.
12. MONO INPUTS Channel 1 and 2 are balanced mono inputs with combo connectors. Use
standard XLR or 6.3mm jack to connect dynamic microphones or line level devices.
CH2 also accepts high impedance music instruments such as electric guitars or electric
bass. To adjust the input level push the corrisponding HI-Z button.
13. BATTERY INDICATORS Indicate the battery charge status (in battery mode). If only the
"red low" indicator lights up, the battery should be charged. The charge indicator lights
up during charging. When the battery is fully charged, the led switches off.
14. LEVEL CONTROL To mix the level of channel 3 or the audio player.
15. INPUT SWITCH Selects the input signal for channel 3. Button pressed: signal of the
audio player. Button released: signal of the RCA or AUX jacks.
16. STEREO INPUT Unbalanced stereo RCA input for channel 3. Use a standard RCA cable to
connect a line level device (Ex. a CD player).
17. AUX INPUT 3.5 mm jack for connecting portable audio units with line level (Ex mp3 player).
18. TONE CONTROLS 2 band tone control for the master signal (BASS low frequencies,
TREBLE high frequencies).
19. ECHO EFFECT Adjust the intensity of the internal effect for the microphone inputs 1-2.
20. TALKOVER Press this button to switch on the talkover function for channel 3. The level of
channle 3 is then temporarly lowered during microphone announcements.
21. KILL FEEDBACK Actve the feedback suppression for the microphone inputs of (channel
1 - 2and the 2 wireless microphones).
4
] Short press swith between play / pause / confirm settings.
] Short press
] [
]
Publicidad
