Mitsubishi Electric TRANE CITY MULTI TPKFYP BM142 Serie Manual De Instrucciones página 10

3. Operation (For Wired Remote controller)
3.5.2 Vane·Vent. (Lossnay)
<Accessing the menu>
Main Main menu
Operation
ON
RETURN SELECT
MENU
OFF
HOLD
Operation
Vane·Louver·Vent. (Lossnay)
High power
Comfort
Main menu: RETURN
Cursor
ON
RETURN SELECT
MENU
OFF
HOLD
<Vane setting>
Fri
Swing Off Off
Vane Vent. Louver
ON
RETURN SELECT
MENU
OFF
HOLD
(Sample screen on CITY MULTI)
Fri
83
Room
Cool Set temp. Auto
83
Mode Temp. Fan
10
Select "Operation" from the Main
menu (refer to page 9), and press
the [SELECT/HOLD] button.
Select "Vane·Louver·Vent.
(Lossnay)" from the Operation
menu, and press the [SELECT/
HOLD] button.
Press the [F1] or [F2] button to go
through the vane setting options:
"Auto", "Step 1", "Step 2", "Step 3",
"Step 4", "Step 5" and "Swing".
Select the desired setting.
Auto
Auto Step 1 Step 2
Step 3 Step 4 Step 5
Swing
Swing
Select "Swing" to move the vanes
up and down automatically.
When set to "Step 1" through "Step
5", the vane will be fixed at the se-
lected angle.
• under the vane setting icon
This icon will appear when the vane
is set to "Step 5" and the fan oper-
ates at low speed during cooling or
drying operation (depends on the
model).
The icon will go off in an hour, and
the vane setting will automatically
change.
<Ventilation setting>
Fri
Low
Vent.
ON
RETURN SELECT
MENU
OFF
HOLD
<Returning to the Operation menu>
Operation
Vane·Louver·Vent. (Lossnay)
High power
Comfort
Main menu: RETURN
Cursor
ON
RETURN SELECT
MENU
OFF
HOLD
Notes:
● During swing operation, the directional indication on the screen
does not change in sync with the directional vanes on the unit.
● Available directions depend on the type of unit connected.
● In the following cases, the actual air direction will differ from the
direction indicated on the remote controller display.
1. While the display is in "STAND BY" or "DEFROST" states.
2. Immediately after starting heat mode (while the system is wait-
ing for the mode change to take effect).
3. In heat mode, when room temperature is higher than the tem-
perature setting.
<[Manual] To Change the Airflow's Left/Right Direction>
* The louver button 7 cannot be used.
• Stop the unit operation, hold the lever of the louver,
and adjust to the desired direction.
* Do not set to the inside direction when the unit is in
the cooling or drying mode because there is a risk
of condensation and water dripping.
Caution:
When you operate the process above, be sure to take measures to
avoid falls.
Press the [F3] button to go through
the ventilation setting options in the
order of "Off ", "Low", and "High".
* Settable only when Lossnay unit
is connected.
Off Low High
Off Low
• The fan on some models of indoor
units may be interlocked with cer-
tain models of ventilation units.
Press the [RETURN] button to go
back to the Operation menu.
High