3. Operation (For Wired Remote controller)
■
Automatic fan speed setting (For wireless remote controller)
It is necessary to set for wireless remote controller only when auto-
matic fan speed is not set at default setting.
It is not necessary to set for wired remote controller with automatic fan
speed at default setting.
1 Press the SET button with something sharp at the end.
Operate when display of remote controller is off.
blinks and Model No. is lighted A
MODEL SELECT
2 Press the AUTO STOP
button.
blinks and setting No. is lighted B
(Setting No.01: without automatic fan speed )
3 Press the temp.
buttons to set the setting No.02.
(Setting No.02:with automatic fan speed )
If you mistook the operation, press the ON/OFF
again from procedure 2.
4 Press the SET button with something sharp at the end.
and Model No. are lighted for 3 seconds, then turned off.
MODEL SELECT
ON/OFF
MODE
CHECK
TEST RUN
14
.
.
button and operate
B
MODEL SELECT
A
TEMP
3
FAN
AUTO STOP
2
VANE
AUTO START
LOUVER
h
min
SET
RESET
CLOCK
3.5. Airfl ow direction setting
3.5.1 Navigating through the Main menu
<Accessing the Main menu>
Main
Main menu
Operation
ON
RETURN SELECT
MENU
OFF
HOLD
<Item selection>
Main
Main menu
Initial setting
Cursor
ON
RETURN SELECT
MENU
OFF
HOLD
<Exiting the Main menu screen>
Fri
83
Room
Cool
Set temp.
Auto
83
Mode
Temp.
Fan
ON
RETURN SELECT
MENU
OFF
HOLD
<Display of unsupported functions>
Title
Not available
Unsupported function
Return: RETURN
ON
RETURN SELECT
MENU
OFF
HOLD
Press the [MENU] button on the
Main display.
The Main menu will appear.
Press [F2] to move the cursor left.
Press [F3] to move the cursor right.
Press the [RETURN] button to exit
the Main menu and return to the
Main display.
If no buttons are touched for 10
minutes, the screen will automati-
cally return to the Main display. Any
settings that have not been saved
will be lost.
The message at left will appear if the
user selects a function not support-
ed by the corresponding indoor unit
model.
9