Publicidad
Idiomas disponibles
Idiomas disponibles
FR
6. OPERATION
ES
Sanding
PT
The sander can be used for most sanding operations on materials such as wood, plastic,
metal and painted surfaces.
IT
EL
PL
RU
Where possible, secure smaller workpiece to prevent them from moving under the sander.
Lower the sander in contact with the workpiece without pressure and then start the sander.
KZ
Move the sander slowly over the surface of the workpiece in a circular or curved motion with
an even, moderate pressure.
UA
If there are still scratches on your work after sanding, try either of the following:
- Go back to a coarser grit and sand the marks out before recommencing with the original
RO
choice or,
- Try using new sanding sheet of the same grit to eliminate the unwanted marks before
EN
progressing to a ner grit and nishing the job.
7. MAINTENANCE
Always disconnect the device before performing any adjustment or
maintenance operation. If the supply cord is damaged, it must be replaced by
the manufacturer or its service agent in order to avoid a hazard.
Disconnect from the power supply immediately if the supply cord is damaged. Take
care not to expose this tool to the rain.
If the carbon brushes need to be replaced, have this done by a quali ed repair person
(always replace the two brushes at the same time)
Cleaning
Avoid using solvents when cleaning plastic parts. Most plastic parts are susceptible to
damage from various types of commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, carbon dust, etc.
178
WARNING : Don't use this machine on plaster.
Wear safety goggles and dust mask.
Publicidad
