EGO COMMERCIAL EDX2000 Manual Del Operador página 26

WARNING:
your hands by wearing heavy gloves
or wrapping the blade with rags or
other materials when performing any
maintenance on the edger blade.
To remove the blade
1. Stop the motor and remove the
battery pack.
2. Lay the edger on its back so that the
blade is facing upwards.
3. Wear protective gloves. Use needle
nose pliers (not included) to remove
the cotter pin from the motor shaft
(Fig. 12).
4. Rotate the blade to align the slot in
the flange with the hole in the gear
case (Fig. 12).
5. Insert a steel rod, such as drill bit,
with diameter around 5/32" (4mm)
into the aligned holes to act as a
stabilizer. Use the multi-function
wrench provided to loosen the nut
CLOCKWISE (Fig. 13).
6. Remove the nut, outer flange, blade,
and the inner flange from the motor
shaft (Fig. 14). Check and replace
them if they are worn.
26
56V LITHIUM-ION COMMERCIAL 8" CORDLESS EDGER — EDX2000/EDX2000-FC
Always protect
12
Cotter Pin
Inner Flange
Gear Case
13
Stabilizer
14
Motor Shaft
Aligned Shaft-locking Holes
Multi-function
Wrench Provided
Slot in the Inner Flange
Inner Flange
Outer Flange
Nut
Cotter Pin
Blade