Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACING OTHER WORN PARTS
Inspect the wear guard periodically. Have
a worn wear guard replaced by EGO
Customer Service as soon as the gear
case becomes visible (Fig. 18).
Have a worn debris flap or depth wheel
replaced by EGO Customer Service.
TRANSMISSION GEARS
LUBRICATION
The transmission gears in the gear case
need be lubricated periodically with gear
grease. Add gear case grease after about
every 50 hours of operation by removing
the sealing screw on the side of the case
(Fig. 19a, 19b).
Do not completely fill the transmission
gear case.
1. Stop the motor and remove the
battery pack.
2. Position the edger upright so that
the sealing screw is facing upwards.
3. Use a 5 mm hex key (not included)
to loosen and remove the sealing
screw in Fig. 19a. Use a 4 mm hex
key (not included) to loosen and
remove the sealing screw in Fig. 19b.
4. Use a grease syringe (not included) to inject 3-5 ml (0.1- 0.17 fl. oz.) grease into
the screw hole.
5. Tighten the sealing screw after injection.
28
56V LITHIUM-ION COMMERCIAL 8" CORDLESS EDGER — EDX2000/EDX2000-FC
18
Worn Wear Guard
19a
Sealing Screw
19b
Gear Case
Sealing Screw
Publicidad
