ErgoAV ERMTS1-01B Manual De Instrucciones página 11

2A-2
2A-3
2A-4
A1
Position the wall plate [01] at your
desired height and line up the
holes with your stud center line.
Level the wall plate [01] and mark
the holes.
01
Drill pilot holes using a 7/32 in
(5.5mm) diameter drill bit. Make
sure the depth is not less than
2 3/4 in (70mm).
01
10
(Not Included)
2 3/4 in (70mm)
NOTE: Do not use a drill to
tighten the lag screws. Only
use a socket wrench.
Install the wall plate using lag
screws [A1]. Tighten the lag
screws [A1] is pulled firmly
against the wall plate. DO NOT
over-tighten the lag screws [A1].
Level
(Not Included)
Level
Pencil
(Not Included)
Electric Drill
(Not Included)
1/2 in (13mm)
Socket Wrench
(Not Included)