ErgoAV ERMTS1-01B Manual De Instrucciones página 13

2B-3
Use the hammer to knock anchors [A2] into the wall. Be sure the anchors
[A2] are seated flush with the concrete surface.
Install the wall plate [01] using lag screws [A1]. Tighten the lag screws
[A1] is pulled firmly against the wall plate [01]. DO NOT over-tighten the
lag screws [A1].
NOTE: Do not use a drill to tighten the
lag screws. Only use a socket wrench.
A2
01
A1
12
(Not Included)
1/2 in (13mm)
Socket Wrench
Level
(Not Included)
(Not Included)
Hammer