Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS (continued)
6.
Remove the bottom gasket (6.1) and mounting nut (6.2) from the drain
assembly (D). Push the bottom gasket (6.1) down onto the top of the
mounting nut (6.2) and twist to attach together.
7.
Insert the drain assembly (D) into the drain hole in the sink (7.1). Ensure the top
gasket (7.2) rests securely between the top of the sink and the top of the drain
assembly (D).
8.
From underneath the sink, screw the bottom gasket (8.1) and mounting
nut (8.2) onto the drain assembly (D) by twisting until secure against the
bottom of the sink.
IMPORTANT: Remember to reconnect the drain body to the P-Trap drain
assembly (not included) before testing the faucet.
9.
Attach the end of each integrated supply line (9.1) from the faucet body (A) to
the hot and cold water supply valves (9.2) under the sink, after making sure
the supply valves (9.2) are clear of any debris. Thread the nut on the end of
the integrated supply line (9.1) onto the outlet of the water supply valve (9.2)
and tighten with a wrench. Do not overtighten.
NOTE: Do not use PTFE pipe tape, plumber's putty, pipe dope, or any other
type of sealing compound on the water inlets or threads. Additional compound
is not necessary. A watertight seal between the supply valve and the nut on the
integrated supply line is achieved by compression.
10.
After installation is complete, remove the aerator (10.1) from the spout (10.2) on
the faucet body (A). Turn on the water supply. Adjust the handle on the faucet
body (A) to the warm position where it mixes hot and cold water. Check for leaks
at all waterway connections. If a leak occurs, gently tighten the nut on the water
connection that is leaking. Fill the sink with water to check the drain for leaks.
If water is leaking from the drain, tighten the mounting nut on the pop-up drain
assembly (D).
After the pop-up drain has been checked for leaks, empty the sink. Run hot and
cold water uninterrupted for at least one minute to flush away any debris that
could cause damage to the internal parts.Turn off the water and reattach the
aerator (10.1) onto the spout (10.2) of the faucet body (A).
5
6
7
7.2
D
7.1
8
D
8.1
8.2
9
9.1
9.2
10
A
10.2
10.1
D
6.1
6.2
Publicidad
