Descargar Imprimir esta página

SEVERIN FKS 8841 Instrucciones De Uso página 10

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 30
GB
Translation from original operating
manual
Refrigerator for bottles
Dear Customer,
Before using the appliance, read the
following instructions carefully and keep
this manual for future reference. The
appliance must only be used by persons
familiar with these instructions.
Connection to the mains supply
∙ This appliance must only be
connected to a correctly installed
power socket with an earth
connection. The mains voltage must
correspond to the voltage specified
on the type plate of the appliance.
This appliance is compliant with the
mandatory directives for CE marking
(see EU Declaration of Conformity at
the end of this manual).
∙ Do not operate this unit by means of
a transformer or, together with other
electrical appliances, by means of an
extension cable.
∙ To prevent noise vibration, ensure that
the power cord does not touch any
part of the rear of the unit (e.g. the
heat-exchanger).
∙ When setting up the appliance, ensure
that the power cord is not pinched or
damaged.
∙ Portable multiple sockets or power
supplies must not be placed on the
rear of the appliance.
∙ Ensure that you can pull out the power
plug at any time.
10
∙ A complete switch-off will only occur
by pulling out the power plug.
Designated use
∙ The appliance is a compressor cooling
device that is exclusively intended
for the cooling and storage of bottles.
No other food may be stored in this
appliance.
∙ The appliance should be operated in
conditions where the relative humidity
is no more than 60%.
∙ The product specifications at the end
of this manual contain information
on the ambient temperature range
suitable for this appliance.
∙ No responsibility is accepted if
damage results from improper use, or
if these instructions are not complied
with.
Important safety instructions
∙ This appliance is intended for
commercial use.
The appliance contains
eco-friendly yet
flammable refrigerant
isobutane (R600a).
Ensure, therefore, that the cooling
circuit does not get damaged during
transportation and after installation of
the appliance. If damage to the cooling
circuit does occur, do not switch on or
connect the appliance to the mains
power. If there is an open fire or any
other sources of ignition in the vicinity
of the refrigerant, ensure they are
removed and the room is thoroughly
ventilated.

Publicidad

loading