Briel ES35 Manual De Instrucciones página 4

3. SPECIAL CORD SET INSTRUCTIONS
A. A short power-supply cord is provided to reduce risks resulting from becoming entangled in or tripping over a longer cord;
B. Longer extension cords are available and may be used if care is exercised in their use;
C. If an extension cord is used, the marked electrical rating of the extension cord should be at least as great as the electrical rating of
the appliance. If the appliance is of the grounded type, the extension cord should be a grounding type 3-wire cord, and the longer
cord should be arranged so that it will not drape over the counter-top or table top where it can be pulled on by children or tripped over;
D. Your product is equipped with a polarized alternating current line plug (a plug having one blade wider than the other). This plug will
fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the
plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the
polarized plug;
Note: Paragraph D only applies to USA and Canada.
4. PREPARATION
All accessories (porta-filter, measuring spoon, filters, water tank) must be washed with detergent and tepid water.
Remove the water reservoir by pulling it outward and fill it with cold water.
Turn the machine ON.
Place an Espresso cup under the brew head (with the porta-filter inserted in the brew head) and turn ON the coffee function. You will
hear the sound of the pump and, after a few seconds, water will flow from the brew head. Allow water to flow until cup is filled.
When the machine is new, it is recommended that several cups of water be allowed to flow through to clean it.
You must never operate the machine without water in the tank!
5. MAKING ESPRESSO
Preparing the appliance:
Remove the water tank by pulling it outward and fill it with cold water
Insert plug into a wall outlet
Turn the machine ON
Choose the Cremaker filter
With ground coffee:
Fill the chosen filter with ground coffee using the measuring spoon provided. Place one level measure of coffee in the filter for
each cup of Espresso. Do not overfill. Gently tamp down coffee with the tamper on the machine. Insert porta-filter into brew head,
by turning it to the right as you face machine;
Place one or two Espresso cups on the drip tray to line up with the spouts of the porta-filter.
With coffee pods:
With the coffee pod, you may prepare only one Espresso at a time!
Place a fresh coffee pod in the Cremaker filter. Insert porta-filter into brew head, by turning it to the right as you face machine;
Place one Espresso cup on the drip tray to line up with the spouts of the porta-filter.
Brew coffee:
Make sure steam control is closed;
When the machine is ready and the temperature ok, the green light will appear;
After completing all the above steps, your machine is now ready to brew coffee;
Press brew coffee position. After a few moments, Espresso will start to flow into the cups;
The more water you allow to flow, the softer the coffee will be. The espresso will have a light brown foam floating on top;
To stop the water flow, simply press the coffee button again.
Porta-filter removal:
After having brewed coffee, wait 10 to 15 seconds before removing the porta-filter.
To make more Espresso or to remove the porta-filter, move handle to the left. Be careful, as hot water will be on top of the ground
coffee|coffee pod in the porta-filter;
Knock out used coffee grinds or coffee pod from filter;
After Espresso preparation, rinse both the porta-filter and the used Cremaker filter.
For more Espresso, repeat the above steps.