Conrad WS 8113 Manual De Instrucciones página 7

Part B – Buttons and backcase
B1: "SNOOZE" touch position
B3: " " button
B5: " " button
B7: " " button
B9: Support frame
Part C –Wireless outdoor sensor:
C1: Transmission signal LED
C2: "RESET" button
C3: Channel switch (channel 1 / 2 / 3)
C4: Battery compartment
Initial operation:

Open the battery compartment cover of the base station and the outdoor sensor.

Insert 4 x AA batteries by observing polarity [ "+" and "-" marks] into the base station.

Insert 2 x AA batteries by observing polarity [ "+" and "-" marks] into the outdoor sensor.

Replace the battery compartment covers on the base station and the outdoor sensor.

When you insert the batteries, all the icons on the LCD display will briefly light up for 3 seconds, and you will hear a signal tone. The station will start to
display the indoor temperature.

The base station will now start to make a connection to the outdoor sensor. This operation takes about 3 minutes and is displayed by a flashing reception
antenna symbol in the "OUTDOOR" display area on the station.

After the base station establishes a connection with the outdoor sensor, it will automatically enter the radio control time reception mode.
Notes:

If the base station does not establish a link with the outdoor sensor, it will automatically enter the receiving mode of the radio control time after 3 minutes.

The base station searches for the synchronization signal of the outdoor sensor for 3 minutes. Please let the outdoor sensor power on as much as possible
within three minutes to prevent the reception time from being missed.
B2: " " button
B4: " " button
B6: " " button
B8: Hanging hole
B10: Battery compartment
EN2