probst LF-75/125 Instrucciones De Uso página 36

Adjustments
3.4 Adjust the roof profile
Following needs to be observed, when working with LF-170/310:
When the working width is 235 cm or less, additional clamping plates have to be used, so no material
can collect between the sheets. The usage of the clamping plates is described in the chapter „Adjust
the working width for LF-170/310".
3.4.1 Set an angle
To set the maximum angle the screeding bars (5) have to be extended approximately to the half.
1. Slightly release the ring nuts (4).
4
3. Slightly release the rear ring nut (6).
51000084/51000085/51000086
2. Adjust the screeding bars (5) to the desired
working width.
5
4. Adjust the desired angle by pulling the
screeding bars (5) by the middle ring nut (4) upwards.
6
11 / 18
4
5
GB