LF allen + roth LWFP62-8 Instrucciones De Montaje página 4

J
ASSEMBLY INSTRUCTIONS
1a. Unpack the unit and confirm that you have all the hardware and
required parts. Assemble the unit on a carpeted floor or the empty
carton to avoid any scratch.
1b. Securely screw the cam bolts (CC) into the designated small holes
on the top panel (K), middle crossbar (X) and partition panels (T and
U). Fully tighten with a Phillips screwdriver.
Hardware Used
CC Cam Bolt
2. Glue two wood dowels (DD) into the inner holes of middle crossbar (X)
and attach it to the media shelf (L) by engaging three cam locks (BB).
Hardware Used
BB Cam Lock
DD
30 mm Wood Dowel
PP
Glue
3a. Glue two 20 mm wood dowels (EE) into the inner holes of each
middle trim (B1).
3b. Fasten the middle trims (B1) to the partition panels (T and U) with
three 25 mm screws (GG) respectively.
Hardware Used
EE
20mm Wood Dowel
GG
M4 x 25 mm Screw
1
X
K
x 19
2
The cam locks
face upward
X
x 3
DD
DD
x 2
L
x 1
The top edges
are even
3
B1 B1
T
x 4
EE
x 6
GG
6
Lowes.com/allenandroth
ASSEMBLY INSTRUCTIONS
4a. Glue two 30 mm wood dowels (DD) into the upper side holes of top
front molding (W) and four wood dowels (DD) to the media shelf (L)
of both ends.
4b. Attach the top front molding (W) and the media shelf (L) between the
partition panels (T and U) by engaging six cam locks (BB).
Hardware Used
CC
Cam Lock
BB
DD 30 mm Wood Dowel
PP Glue
U
T
5. Securely screw the cam bolts (CC) into the designated small holes on
the bottom panel (M), front skirting (O) and side skirtings (P and Q).
Fully tighten with a Phillips screwdriver.
Hardware Used
BB
CC Cam Bolt
6. Glue two 30 mm wood dowels (DD) into the lower side holes of
rear skirting (N) and attach it between the side skirtings (P and
Q) by engaging two cam locks (BB).
Hardware Used
U
BB Cam Lock
DD
30 mm Wood Dowel
PP
Glue
GG
4
W
L
x 6
T
x 6
x 1
The cam locks
face inward
5
M
x 18
O
P
6
N
BB
x 2
BB
x 2
DD
Q
The cam locks
x 1 face inward
7
Lowes.com/allenandroth
U
DD
BB
CC
Q
P
DD