LF allen + roth LWFP62-8 Instrucciones De Montaje página 8

ASSEMBLY INSTRUCTIONS
25. Fully plug the USB connector of the ember bed (E) into the back
port of heater (A).
26. Slide the glass (I) into the inner U-channels on both upright arms
(B and C) until the glass sits onto the heater (A). If needed, push
top of upright arms in or out to accommodate glass. Make sure
the top of the glass (I) is flush with the top of both upright arms
(B and C).
27. Position top connector strap (D) over the glass (I) and upright
arms (B and C). Follow orientation shown below.
25
A
E
26
The warning labels on glass
should face outward
B
I
C
A
27
D
B
I
H
C
14
Lowes.com/allenandroth
ASSEMBLY INSTRUCTIONS
28. Fasten connector strap (D) to both upright arms (B and C) using
two screws (AA) as show below. Holes must be in line for screw
to pass through.
Hardware Used
AA M4 x 10 mm Screw
A
29. The firebox is now ready for the next assembly step.
I
30a. Lift the fireplace insert carefully onto the firebox short
supports (A1) and in the back of the assembled mantel and
center it in the opening. DO NOT drag the insert across the
firebox short supports as it may scratch them.
The bevel edge
30b. Use the pilot holes as a guide, fasten two L-shaped brackets
faces inside the unit.
(MM) onto the firebox back holder (Y) with four pan head
screws (II). Make sure that the right angle side is flush with
the short edge of firebox back holder (Y).
D
30c. Fasten the firebox back holder (Y) between the partition
panels (T and U) with four screws (MM), using the pilot holes
as a guide.
Hardware Used
H
MM L-shaped Bracket
II Pan Head Screw
28
B
D
H
x 2
C
AA
29
30
A1
x 2
x 8
15
Lowes.com/allenandroth
D
H
Y
II
MM
Y
Electric Firebox
II
MM